Hello, I am looking for someone to write an article on Design, Implement, and Test a Timer: Prototype Product. It needs to be at least 1500 words. Pin 3 – also known as the output pin on this chip. If pin 3 and pin 7 happen to be in phase, Pin 3 is forced to go to a higher state. of about 2V less than the rail, whereas The LOW state is reached at around the voltage of about 0V to 0.5V. This denotes that pin 3 will produce only 200mA
Pin 4 – also known as the RESET pin. it is constantly connected internally to a HIGH state via a 100k resistor. The voltage must be below 0.8V for this pin to be reset.
Pin 5. Also called the control pin of the 555 timer chip. This pin varies the timing of the RC network when the voltage applied to this pin varied.
This denotes that pin 3 will produce only 200mA
Pin 6 – this is the threshold pin of the chip. Its function is to detect two-thirds of the rails voltage for it to produce a LOW output when pin 2 is in a HIGH state. this pin has a very high impedance and thus it is activated at around 1uA.
A 555 timer-based oscillator is a circuit that produces high and clear free waveforms. One can easily manipulate the output of these waveforms by connecting an RC circuit to a capacitor and two resistors. This circuit demonstrates a relaxation oscillator that generates stable squire waveforms. these waveforms may comprise duty cycles that are varying from 50-100% or may have a fixed frequency of around 500 kHz. These are different from a monostable circuit that stops after the preset time has elapsed. this oscillator has its own triggering mechanism which is arrived at by interfacing the trigger input pin2 and pin6 which is the threshold voltage. This feature qualifies this device as a stable oscillator circuit.
The oscillator circuit above shows pin two and pin six connected together. This permits the circuit to have a self-triggering mechanism in each operation cycle. Thus the circuit can be said to be an operation free-running oscillator.
This circuit above shows a voltage-to-frequency converter. this is so because the output frequency can be manipulated by varying the input voltage. Pin 5 the voltage control pin controls the trigger and the optimum levels. ven as two-third of the Vcc. This results from the internally build voltage divider. If an external voltage is applied at this specific point the control voltage can be changed. .
- Assignment status: Already Solved By Our Experts
- (USA, AUS, UK & CA PhD. Writers)
- CLICK HERE TO GET A PROFESSIONAL WRITER TO WORK ON THIS PAPER AND OTHER SIMILAR PAPERS, GET A NON PLAGIARIZED PAPER FROM OUR EXPERTS
QUALITY: 100% ORIGINAL PAPER – NO PLAGIARISM – CUSTOM PAPER